|
Select a product category:
|
|
|
W030
Spindle Moulder - FREE 1/2" ROUTING ADAPTOR
- only £599.00
- SPECIAL OFFER!!
|
|
|
|
Click image to enlarge...
|
- FREE 1/2" ROUTING ADAPTOR
- CAST IRON TABLE
- RISE & FALL SPINDLE
- 4 SPINDLE SPEEDS
- TENONNING CARRIAGE
- INDEPENDENTLY ADJUSTABLE FENCES
- FULL CUTTER GUARDING
- DUST EXTRACTION OUTLET
|
Fitting neatly into the gap between the heaviest router table and an industrial sized spindle moulder this machine is ideally suited to small professional workshops.
Now available; The new Mark III model has been improved again. We have increased the maximum tooling size and increased the Vertical stroke, to allow access to even more tooling. We have also added a 4th speed. The new low speed enables the moulder to be converted into a spindle sander and is offered as an optional item.
A precision ground cast iron table, a steel base cabinet and a 2hp induction motor are the basic ingredients which make up this fantastic new spindle moulder. The height of the spindle is controlled by the large hand wheel which can then be locked in position.
A simple belt change selects the correct speed for the tooling.
The body of the fence is cast iron with a dust outlet at the centre. The two fences are adjustable to set the width of the opening, to suit the cutters being used. The outfeed fence can also be stepped out, controlled by a fine pitch thread adjuster, for operations where the complete edge of the workpiece is being removed.
Fully adjustable guards are connected to a hinged plate which can quickly be lifted to allow clear access to change the tooling.
The sliding carriage consists of a cast iron table with four bearing guides running along an aluminium extrusion. The fence angle can be set accurately between 90 and 45 degrees with a useful stop to quickly return to 90 degrees again. A hold down clamp and a length stop complete the equipment.
SPECIAL OFFER : Order now and receive a FREE Routing adaptor to allow 1/2" shank router bits to be used. Worth £49 !!
Supplied with sliding carriage, 100mm diameter extraction outlet, 4 adjustable height rubber feet, cable and plug.
Read an independant test report:
Good Woodworking Magazine Review May 2008
|
Specification:
|
Motor (Induction) |
1500w, 240v |
Table Size |
600mm x 400mm |
Spindle Diameter |
30mm |
Speeds |
4 ( 1400, 4000, 6000 & 9000 ) rpm |
Cutterblock Vertical Stroke |
110mm |
Maximum Tooling Diameter (Table Aperture) |
160mm |
Maximum Toolng Diameter (Above Table) |
160mm |
Table Height |
870mm |
Dust Extraction Outlet Diameter |
100mm |
Dimensions (WxDxH) |
830mm x 1070mm x 1280mm |
Weight |
95Kg |
Rating |
Light Trade |
Warranty |
1 Year |
|
